As you will recall the Synthetic Resin Roof Tile was developed as an alternative to the traditional roofing tiles available on the market. The product specification for Synthetic Resin Roof Tile states that it's suitable for flat roofing over three: twelve, five: twelve and greater. In addition, the product should be able to withstand heavy snow loads and high wind loads. The thickness of the Resin Roof Tile should range from two and one-half inches to three inches or more. The most common thicknesses are two and one-half inches, three inches and six inches.
As with any other tile or slat, the synthetic roof sheets should be properly protected against moisture. This can be done by a periodic application of a high-quality water-based silicone moisture inhibitor (caustic resistant). Also, in the handling process, care should be taken to not allow air to become trapped within the tiles.
Another way to protect the surface of the tiles from moisture is using a chemical sealer. This should be a very good and proper anti-corrosion treatment for Synthetic Composite Roof Tiles. Please note that the use of an anti-corrosion agent is only recommended for the new installation of roofing tiles, and not for existing roof tiles. If you have an existing roof, you may consider low maintenance, low-cost approach by using a premium grade synthetic resin roof tile with an anti-corrosion agent.
An easy checking method to determine if your roof tiles are in need of a Synthetic Resin Roof Tile fix is looking at the edge jamb. If there is an unusually long edge jamb that is more than six inches longer than the main span of the tile, it's probably time to replace them. Also, check the thickness of the synthetic resin roof tile material. A typical six-inch thickness is considered to be a very effective width.
A synthetic resin roof tile and new heat insulation should be installed to prevent any moisture intrusion into the home. Check with the Synthetic Resin Tile manufacturer to identify what the best method for installation is. You may choose to have the tiles bonded to the roof, or you may want to choose an interlocking joint system. The choice is yours and what is best for your needs.
Make certain that all the components of the tile are the same size before you place the first one down. Otherwise, if you end up installing the wrong one, the result will be uneven coverage. Another method that many people use is to lay out the tiles according to their effective width and then cut each one accordingly. Many times with new home kits, you can select the appropriate tile size to fit, but always double-check with the company selling the product that the proper size was selected. Hopefully, these tips will help you select the most effective width synthetic resin roof tile for your home.
Comments